Installation Notes; Operation Notes - AMSTRAD cpc 6128 User Instruction

IMPORTANT
You must read this ....
Installation Notes
1. Always connect the Mains Lead to a 3-pin plug following the instructions
contained in part 1 of the Foundation course.
2. Never attempt to connect the system to any Mains Supply other than
220-240V ~ 50Hz.
3. There are no user serviceable parts inside the system. Do not attempt to gain
access into the equipment. Refer all servicing to qualified service personnel.
4. To avoid eye-strain, the monitor should be placed as far away as possible from
the keyboard and operated in an adequately lit room. The monitor
BRIGHTNESS control should be kept to as Iowa setting as possible.
5. The computer should be placed centrally in front of the monitor, but as far away
from the screen as possible. For maximum data reliability, the disc drive section
of the computer should NOT be placed directly in front ofthe monitor, but to the
right of it. Do not place the computer close to any source of electrical
interference.
6. Always keep disc dri ves and discs away from magnetic fields.
7.
If you are operating a 2-drive system, keep the interconnecting ribbon cable to
the 2nd drive, away from Mains Leads.
8. Do not block or cover any ventila tion holes.
9. Do not use or store the equipment in excessively hot, cold, damp, or dusty areas.
Operation Notes
(Don't worry if you are a little baffled by the technical jargon in this section; the
importance of these warnings will become clearer as you work through this manual.)
1.
Never switch the system on or off with a disc in the drive. Doing so will corrupt
your disc, losing valuable programs or data.
Warnings CPC 6128