Connecting The Computer To An Mp2 Modulator/Power Supply Unit - AMSTRAD cpc 6128 User Instruction
Integrated computer/disc system
Hide thumbs
Also See for cpc 6128:
- Service manual (32 pages) ,
- Service manual (31 pages) ,
- Service manual (31 pages)
Table of Contents
Advertisement
Connecting the computer to an MP2
Modulator/Power supply unit
The MP2 is an additional item that you may wish to purchase if you are currently
using your CPC6128 computer with the GT65 green tube monitor. The MP2 enables
you to to use the computer with your domestic colour TV and thereby enjoy the full
colour facilities of your CPC6128 computer.
The MP2 should be positioned next to the right hand end ofthe CPC6128.
1.
Make sure that the MP2 is not plugged into the Mains supply socket.
2.
Connect the lead from the MP2 which is fitted with the larger (6-pin DIN) plug,
into the rear socket ofthe computer marked MONITOR.
3.
Connect the lead from the MP2 which is fitted with the smaller (5V DC) plug,
into the rear socket on the computer marked 5V DC.
4.
Connect the lead from the MP2 which is fitted with an aerial plug, into the
AERIAL or ANTENNA socket of your TV set.
5.
Connect the lead from the back of the computer, which is fitted with a small
(12V DC) plug, into the socket at the rear of the MP2.
Foundation Course
Chapter 1 Page 3
Advertisement
Table of Contents
