Switching On-Cpc6128 And Mp2 Modulator/Power Supply System - AMSTRAD cpc 6128 User Instruction

Switching on - CPC6128 and MP2
Modulator/Power supply system
Having connected up the system as shown previously, insert the Mains Plug into the
Supply socket.
Switch on the computer using the POWER switch on the back panel.
The red
ON
lamp at the top right of the keyboard should be illuminated, and you must
now tune in your TV set to receive the signal from the computer.
If you have a TV with push-button channel selection, press a channel button to select
a spare or unused channel. Adjust the corresponding tuning control in accordance
with the TV set manufacturer's instructions (the signal will be approximately at
channel 36 if your TV has a marked tuning scale), until you receive a picture that
looks like:
Aftstrad 128H MicrocOMPuter (v3)
®1985 AMstrad ConsuMer Electronics PdlC
and LOCOMotive Software Lt .
BASIC 1.1
Ready
•
Tune in the TV set accurately until the clearest picture is seen. The writing will be
gold/yellow on a deep blue background.
If your TV has a rotary programme selector knob, turn the tuning knob until the
above picture appears and remains perfectly steady. (Again, at approximately
channel 36) .
Foundation Course Chapter 1 Page 5