Copying On A 1-Drive System - AMSTRAD cpc 6128 User Instruction

If you have connected an additional disc drive to the system, the message will say:
Two drives found
At the bottom of the screen, you will see the following:
Copy 7
Format 4
Verify 1
Exit from program 0
This is known as the main DISC KIT menu. The numbers in boxes refer to the
function keys at the right hand end ofthe keyboard (marked f0, f1, f4, and f7), and
pressing one of these keys takes you to your selected menu choice.
Note that pressing function key number 0 at this point will exit from the DISC KIT
program back toCP/M Direct Console Mode (the A> prompt).
We now want to copy a disc, so press function key number 7 (f7).
BEWARE
COPYING ONTO A PREVIOUSLY RECORDED DISC WILL ERASE ITS CONTENTS
Copying on a I-drive system
Assuming that you are using a i-drive system (i.e. you have NOT connected an
additional drive), you will then see the message:
Q
Copy
Any other key to exit menu
At this point, you should remove your master CP/M system disc, and insert the disc
that you wish to copy from. If you wish to copy the CP/M system disc itself, simply
leave it in the drive.
Chapter 1 Page 78 Foundation Course