Tail Enders - AMSTRAD cpc 6128 User Instruction

Keyboard transLations:
This allows new ASCII values to be set into keys, effectively simulating the KEY 0 E F
command in BASIC. The parameters required are the key codes, and the ASCII
values to set into them. For an illustration of key numbers, refer to the diagram at the
top right hand side of the computer, or to part 4 of the chapter entitled 'For your
reference .... ' .
Keyboard expansions:
Effectively simulates the KEY command in BASIC.
Tail enders ....
The 0 I S C KIT 2, S Y S G EN, BOO T G EN, F I L E COP Y, SET UP, C S A V E, and C LOA 0
commands are designed by AMSTRAD, and work exclusively with CP/M 2.2 on the
AMSTRAD system. They have no function on any other CP/M system, although other
manufacturers may supply similar utilities (often with the same names) customised
for their hardware.
The following CP/M 2.2 programs are also available on Side 4 for specialist use, and it
is recommended that the user consult SOFT159 - A Guide to CP/M, or other reference
works.
ASM
DOT
DUMP
EO
LOAD
MOVCPM
SUBMIT
XSUB
8080 Assembler.
8080 Assembly code debugging aid.
Hexadecimal file dump utility.
A simple context editor.
Converts a • HEX file produced by A S M into a • CO M file.
Create
CPIM
2.2 with new (smaller) TPA size.
Console Command Mode batch processing.
Transient program batch processing.
The above programs are for use with CP/M 2.2 (on Side 4), and should not be confused
with other programs on the
CPIM
Plus sides ofthe discs (Sides 1, 2, and 3).
AMSDOS and CPIM Chapter 5 Page 37