Foundation Course; Setting Up; Fitting A Mains Plug - AMSTRAD cpc 6128 User Instruction

Chapterl
Foundation Course
Part 1: Setting Up ....
The CPC6128 can be set up with either:
1. The AMSTRAD GT65 Green Tube Monitor
2. The AMSTRAD CTM644 Colour Monitor
3. The AMSTRAD MP2 Modulator/Power Supply and a domestic (UHF) colour
TV receiver.
Fitting a Mains Plug
The CPC6128 operates from a
220-240Volt~
50Hz Mains supply. Fit a proper Mains
Plug to the Mains Lead of either the GT65, CTM644, or MP2. If a 13 Amp (BS1363)
Plug is used, a 5 Amp Fuse must be fitted. The 13 Amp Fuse supplied in a new plug
must NOT be used. If any other type of Plug is used, a 5 Amp Fuse must be fitted
either in the Plug or Adaptor or at the Distribution Board.
Important
The wires in the Mains Lead are coloured in accordance with the following code:
Blue : Neutral
Brown :Live
As the colours of the wires in the Mains Lead of this apparatus may notcorrespond
with the coloured markings identifying the terminals in your plug, proceed as
follows:
The wire which is coloured BLUE must be connected to the terminal which is marked
with the letter 'N' or coloured Black.
The wire which is coloured BROWN must be connected to the terminal which is
marked with the letter 'L' or coloured Red.
Disconnect the Mains Plug from the Supply Socket when not in use.
Do not attempt to remove any screws, nor open the casing ofthe computer, monitor, or
Modulator/Power supply unit. Always obey the warning on the rating label which is
located underneath the case ofthe CPC6128 and MP2, and on the rear cabinet ofthe
GT65 and CTM644:
WARNING -LIVE PARTS INSIDE. DO NOT REMOVE ANY SCREWS
Foundation Course
Chapter 1 Page 1