Lens Mount - Hamamatsu Photonics C11440-22CU Instruction Manual

•

① Lens mount

C11440-22CU can be attached to C-mount lens or an optics system.
C11440-22CU01 can be attached to F-mount lens or an optics system.
• The depth of the C-mount is 7 mm. Screwing in the mount too far
Note
can scratch the glass surface.
② WATER connector [WATER] (at Water-cooling)
It connects the camera and the circulating water cooler with the cooling water hoses. The insert
position of WATER IN/OUT is not specified.
③ Camera Link interface connector [DIGITAL OUT 1]
This is connected to the Camera Link interface connector 1 on the computer.
④ Camera Link interface connector [DIGITAL OUT 2]
This is connected to the Camera Link interface connector 2 on the computer.
⑤ Trigger input connector [EXT.TRIG]
This is used when the camera is being operated using external synchronization.
Input is 3.3 V LVCMOS level, and input impedance is 10 kΩ.
When an external trigger is input, the trigger is activated at the falling or rising edge of the
signal. (You can choose external trigger polarity between Negative and Positive.)
⑥ Timing out connector 1,2,3 [TIMING 1,2,3]
This is used when peripheral device(s) require synchronization with the camera.
Output is 3.3 V LVCMOS level, and it is output though
Output impedance is 33 Ω.
Note
•
⑦ STATUS lamp [STATUS]
The LED indicates status of camera.
Lighting color
Turn off (no color)
Green
Green
Orange (lighting)
Red
C11440-22CU/C11440-22CU01 Instruction manual_Ver.1.4
Place the camera the water connectors to be lateral side. Do not place
the rear panel of the camera, which connectors are located, to be at the
bottom (Do not block ventilation openings.).
Please see 8. [Water cooling] for details.
•
Determine termination according to cable length and so on.
Status of power distribution
Power off
(Blinking) Initialization
(lighting) Power on
Data transfer
(lighting) Heat up
When the camera heats up, stop operation and unplug the AC
•
adaptor immediately.
BUS TRANSCEIVER IC SN74AVC8T245
.
13