Hamamatsu Photonics C11440-22CU Instruction Manual page 58

C11440-22CU/C11440-22CU01 Instruction manual_Ver.1.4
Free running mode
Exposure time Free running mode
(Slow scan) / Sub-array mode
External trigger mode
Conversion factor
Dark offset
External trigger Function
External signal input
External trigger input level
External trigger output level
External trigger delay function
External signal output
Image processing function
Interface
Lens mount
*
1 Calculated from the ratio of the full well capacity and the readout noise.
*
2 Digital binning processing in the camera.
*
3 Original mode based on 80 bit mode
(2) Power supply specifications
Camera
AC adaptor
Note
56
Input power supply
Typical output
Power consumption
Input power supply
Typical output
Power consumption
• Fluctuations of input power supply voltages are not to exceed ± 10 % of
the nominal voltage.
Camera Link
3 ms to 10 s
129.99 µs to 10 s
3 ms to 10 s
0.46 electrons/count (typ.)
100 counts (at Normal readout)
Edge trigger,
Level trigger,
Synchronous readout trigger,
Start trigger
External input
(SMA connector)
(Camera Link)
3.3 V LVCMOS level
3.3 V LVCMOS level
0 µs to 10 s (10 µs steps)
Global exposure timing output,
Trigger ready output,
Programmable timing output 1,
Programmable timing output 2,
Programmable timing output 3
(Continuous High or Low output)
Real-time offset correction,
Real-time gain correction,
Real-time defect pixel correction (Default)
Camera Link Full
*3
configuration
C-mount (C11440-22CU) / F-mount (C11440-22CU01)
DC 12 V
-
55 W
AC 100 V to AC 240 V 50 Hz / 60 Hz 2.5 A
DC 12 V 8.34 A
70 VA
USB 3.0
External input
(SMA connector)
USB 3.0 Super Speed