Table of Contents
Advertisement
GATE OPERATOR INSTALLATION
GATE OPERATOR INSTALLATION
Limit Switch Setup
STEP 6
Remove the lead screw cover:
a) Remove the screw and
b) Slide out the cover.
STEP 7
Loosen the screws on the limit switch
holders and position the limit switches to
the desired position.
Move the gate manually and ensure that the
limit switch gets actuated at the desired
open and closed position. The limit switch
will click when engaged by the lead screw
carrier.
Retighten the screws on the limit switch
holders once the proper position has been
determined (DO NOT OVERTIGHTEN).
Note: Leave cover off until after the installation
of the control box and the electrical
installation. Verify that the operator opens
and closes to the desired position under
power. Make any adjustments as necessary.
STEP 8
Replace the cover taking care to position the
shaft properly inside the endcap.
14
TECHNICAL SUPPORT 1 800 908 0884
Pull Cover
Forward and
Remove
Adjust the
Limit Switches
18
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
