Table of Contents
Advertisement
min.
MAX
IMPORTANT SAFETY INFORMATION
IMPORTANT SAFETY INFORMATION
Hold Open
Timer
WARNING - Not following these instructions may cause severe injury or death to persons.
Open
Edge Sensor (contact sensor) Installation
Secondary Entrapment Protection
Open Commands
Open Commands
Edge sensor or like must be installed to reduce the risk of entrapment.
Use only Miller Edge 3-sided activation type MGR20 or MDS20 to comply with UL325
One or more contact sensors shall be located on the inside and outside leading edge
of a swing gate. Additionally, if the bottom edge of a swing gate is greater than 6
inches (152 mm) above the ground at any point in its arc of travel, one or more
contact sensors shall be located on the bottom edge.
1. A hardwired contact sensor shall be located and its wiring arranged so that the
communication between the sensor and the gate operator is not subjected to
mechanical damage.
2. A wireless contact sensor such as one that transmits radio frequency (RF) signals
to the gate operator for entrapment protection functions shall be located where
the transmission of the signals are not obstructed or impeded by building
structures, natural landscaping or similar obstruction. A wireless contact sensor
shall function under the intended end-use conditions.
Manual Release
When manual operation is required:
Insert the key and rotate clockwise. This will
allow the gate to be moved manually.
To reengage the gate operator, turn the key
counter-clockwise
Attention: Lock and release operations MUST
be performed with motor NOT RUNNING.
Safety Connector
Loop Connector
TECHNICAL SUPPORT 1 800 908 0884
Low Battery
Low Battery
Motor Sensor
Motor Sensor
Mag.
Lock
N.C.
COM
N.O.
3-Sided Edge Sensor
Radio Station
Radio Station
3-Sided Edge Sensor
Unlock
Lock
7
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
