Radio Receiver - Viking G-5 Installation Instructions Manual

ACCESSORY CONNECTIONS ACCESSORY CONNECTIONS

Radio Receiver

When connecting the Radio Receiver carefully verify the proper connections.
The maximum voltage that the control board provides for external accessories is the
maximum voltage of the battery, which is about 28 volts.
In the event of an electrical short in the power to the accessories, the board will
protect itself by shutting down and will remain shut down until the short is corrected.
The control board provides two modes of
operation that a radio receiver can control
the gate:
Open-Stop-Close
1. By having the radio receiver connected as
illustrated and with the Hold Open Timer
OFF (see page 27):
Every command of the radio transmitter
will control the gate as follow:
a) First command opens the gate,
b) Second command stops the gate and
c) Third command closes the gate
d) Any subsequent commands will continue
in the same order to control the gate.
This type of configuration is not
recommended for a commercial
installations.
Master/Slave Master/Slave
Open Only
2. By having the radio receiver connected as
UL
Siren
illustrated and with the Hold Open Timer
ON (see page 27):
Each command of the radio transmitter is
ALWAYS AN OPEN COMMAND to the gate.
Overlap Delay
Close Stop Open
Guard Station Guard Station Open Commands Open Commands
TECHNICAL SUPPORT 1 800 908 0884
Obstruction
Center Safety
Sensor
Loop Loop
min. MAX
Hold Open
Timer
Safety Connector Loop Connector
Fail
Safe/Secure
UL Radio
Sensor Rec.
Mag.
Lock
Radio Station Radio Station
COM
NO
Gnd
+24VDC
Charger Charger
Power Power
Low Battery Low Battery
Motor Sensor Motor Sensor
N.C.
COM
N.O.
External
Accessories
23