Table of Contents
Advertisement
Junction Box Adapter (SV-JBA) Installation Instruction
(Sold Separately)
Inside the box:
A. Junction Box Adapter
B. Pack of four (4) machine screws
C. One double-sided hex key
D. Pack of four (4) screws and four (4)
anchors
NOTE: Anchors and screws are good to be
used for concrete, wall block and red bricks.
NOTE: Screws by themselves can be used
in wood.
E. Mounting template
Not included but needed:
#2 Phillips screwdriver
Wall Mount, MD-WMT
¾" NPT Conduit (if necessary)
A
B
C
Image 28
1. Remove junction box adapter and hardware
from the box
2. Remove the conduit plug by first removing
the socket set screw using the provided hex
key (C) as shown on Image 29.
3. Attach the junction box adapter to the wall
using screws or any optional hardware
suitable for the mounting surface.
D
E
Image 29
Image 30
4. Attach the wall mount to junction box
adapter then attach cap to the wall mount
as shown in Image 30.
5. Connect ¾" NPT Conduit to the junction box
adapter.
6. Run Ethernet cable and outside power
cable (if necessary) through the Junction
Box Adapter and Wall Mount.
7. For installation of the camera, please
reference "Mounting the Camera."
Conduit hole
Advertisement
Table of Contents
