Table of Contents
Advertisement
Optional: Connecting Alarm I/O:
34. To use the Alarm I/O, connect the alarm I/O
to the pigtail cable connector as shown in
Image 2.
NOTE: Table 2 shows the electrical
characteristics and Table 3 shows cable color
for digital I/O.
Electrical
Characteristics:
Input voltage (V)
(measured between
+ and – terminals)
Output current (mA)
(measured between
+ and – terminals)
Applied Voltage
Rage: 0 - 80V
NOTE: Both the input and the output are
electrically isolated from the rest of the
camera's electrical circuitry via general-purpose
photo couplers. The input is additionally
protected with a serial 250 Ohm resistor and a
debouncing circuit. Duration of any input signal
should be at least 5ms to comply with the
requirements of the debouncing circuit.
Yellow
Red
Green
Black
Page | 15
support@arecontvision.com
Min
Max
ON
2.9
6.3
OFF
0
1.3
ON
-
50
OFF
-
0.1
Table 2
Digital IN +
Digital IN –
Digital OUT +
Digital OUT -
Table 3
Arecont Vision MegaBall
Software Installation
35. Install the AV100 or AV200 application
manager Software found on the CD.
NOTE: you can download latest version AV100
and AV200 and installation manual on website
Camera
http://www.arecontvision.com/softwares.php
IR & DN
Versions
DN
version
Only
®
2 Installation Manual
Advertisement
Table of Contents
