Table of Contents
Advertisement
Dome Cover (Bubble) Installation
(Optional):
23. Remove the O-ring (Image 1D on Page 4)
from the bezel by pushing on the 4 drift pins
on the back of bezel shown in Image 21.
24. Attach the provided dome cover (Image 1D
on Page 4) to the bezel as shown in Image
22.
Drift Pin
Image 21
Image 22
25. Remove the protective film from the bubble.
NOTE: Take precaution not to scratch the
bubble.
26. Secure the dome cover to the camera using
the provided Security L-Key (Image 1F on
Page 4)
Adjusting the Remote Focus and Zoom:
(PM models only)
27. To adjust focus or zoom, open the camera
web interface and click the "Focus" tab as
shown in image 23.
28. To manually adjust zoom, click the "+20",
"+5", "+1", "-20", "-5", "-1" buttons to zoom in
and out, adjusting the field of view.
NOTE 1: "+20" zooms in 20x further than "+1"
NOTE 2: If the "Enable Auto Focus after zoom"
option is checked as shown in image 23, the
focus will automatically be adjusted when zoom
is changed.
29. Set up a focus area (if necessary) by
drawing a rectangle with the mouse (by left-
clicking and dragging the mouse to a
desired zoom size) shown in Image 23.
30. To automatically adjust focus, choose "Full-
range Focusing" or "Fast Focusing"
depending on the image clarity as shown in
image 23.
31. If the image is completely out of focus,
choose "Full-range Focusing" to scan the
full focus range and find the best focus
position.
32. If the image is slightly of out of focus,
choose "Short-rang Focusing" to fine tune
and quickly get a precise focus position to
save time.
33. 31. To manually focus, click the "+20", "+5",
"+1", "-20", "-5", "-1" buttons to fine tune the
focus.
Advertisement
Table of Contents
