Obtaining A Headset - Cisco 7921G User Manual

If you want to...
Switch to the desktop charger
speakerphone
Switch to the handset from
the desktop charger
speakerphone
Adjust the volume level for a
call

Obtaining a Headset

Your phone supports headset jack types with a 2.5 mm, 3-band/ 4 connector. For information about
purchasing headsets, see
60
Then...
1. Place the wireless IP phone in the desktop charger cradle.
"AC connected!" displays on the screen.
2. Press down on the top of the phone.
"Docking connected!" displays on the screen and the
displays on the phone status line.
The desktop charger speaker and microphone are connected.
3. Place and receive calls.
Use all the buttons on your phone, including
You can use the headset to answer calls when the phone is in the
desktop charger.
Note The internal, single-direction microphone is located on the lower
left side of the phone (two small holes). For best results, place
the desktop charger in front of you when using the
speakerphone.
1. Hold the top of the phone and move it forward before lifting it
off the desktop charger.
2. Use the handset to continue with the call. The desktop charger
speaker and microphone disconnect.
Note You cannot turn off the desktop speaker by using the
button.
During a call, press
headset or
desktop charger.
Note The new volume level is preserved for future calls after the
phone is powered off.
Headset Information, page
to adjust the volume for the handset, speaker,
14.
icon
and .
OL-15163-01