To Lock The Doors And Swing Gate; To Turn Off "Flash Lights With Lock; Programming Additional Transmitters; General Information - Jeep Wrangler Owner's Manual

The system can be programmed to unlock all
the doors upon the first UNLOCK button press
by using the following procedure:
1. Press and hold the LOCK button on a pro-
grammed RKE transmitter.
2. Continue to hold the LOCK button at least
4 seconds, but not longer than 10 seconds,
then press and hold the UNLOCK button on the
RKE transmitter.
3. Release both buttons at the same time.
4. Test the feature while outside of the vehicle,
by pressing the LOCK/UNLOCK button on the
RKE transmitter.
NOTE:
Pressing the LOCK button on the RKE trans-
mitter while you are inside the vehicle will
activate the Vehicle Security Alarm. Opening
a door with the Vehicle Security Alarm acti-
vated will cause the alarm to sound. Press
the UNLOCK button to deactivate the Ve-
hicle Security Alarm.
5. If the desired programming was not
achieved or to reactivate this feature, repeat
the above steps.

To Lock The Doors And Swing Gate

Press and release the LOCK button on the RKE
transmitter to lock all doors. The turn signals
will flash and the horn will chirp once to ac-
knowledge the lock signal.
To Turn Off "Flash Lights With
Lock"
NOTE:
The "Flash Lights With Lock" feature can be
turned on or off using the following steps:
1. Press the RKE transmitter UNLOCK button
for 4 to 10 seconds.
2. While the UNLOCK button is pressed, (after
four seconds) press the RKE transmitter LOCK
button. Release both buttons.
3. Test the "Flash Lights With Lock" feature
outside of the vehicle, by pressing the RKE
transmitter LOCK button with the ignition in the
LOCK position, and the key removed.
NOTE:
Pressing the RKE transmitter LOCK button
while you are in the vehicle will activate the
Vehicle Security Alarm. Opening a door with
the Vehicle Security Alarm activated will
cause the alarm to sound. Press the RKE
transmitter UNLOCK button to deactivate
the Vehicle Security Alarm.
The "Flash Lights With Lock" feature can be
reactivated by repeating this procedure.
Programming Additional
Transmitters
Refer to Sentry Key "Customer Key Program-
ming."
If you do not have a programmed RKE trans-
mitter, contact your authorized dealer for de-
tails.

General Information

Transmitter and receivers operate on a carrier
frequency of 433.92 MHz as required by EEC
regulations. These devices must be certified to
conform to specific regulations in each indi-
vidual country. Two sets of regulations are
involved: ETS (European Telecommunication
Standard) 300–220, which most countries use,
and German BZT federal regulation 225Z125,
which is based on ETC 300–220 but has addi-
tional unique requirements. Other defined re-
17