To Lock The Doors And Swing Gate; To Turn Off Flash Lights With Lock - Jeep Wrangler 2015 Operating Information Manual

2. Continue to hold the RKE transmitter LOCK
button for at least four seconds, but not
longer than 10 seconds, then push and hold
the RKE transmitter UNLOCK button.
3. Release both buttons at the same time.
4. Test this feature while outside of the vehicle
by pushing the LOCK/UNLOCK button on
the RKE transmitter.
NOTE:
Pushing the RKE transmitter LOCK button
while you are inside of the vehicle will acti-
vate the Vehicle Security Alarm. Opening a
door with the Vehicle Security Alarm acti-
vated will cause the alarm to sound. Push
the RKE transmitter UNLOCK button to de-
activate the Vehicle Security Alarm.
5. If the desired programming was not achieved
or to reactivate this feature, repeat the above
steps.
NOTE:
Pushing the RKE transmitter LOCK button
while you are inside of the vehicle will acti-
vate the Vehicle Security Alarm. Opening a
door with the Vehicle Security Alarm acti-
vated will cause the alarm to sound. Push
the RKE transmitter UNLOCK button to de-
activate the Vehicle Security Alarm.

To Lock The Doors And Swing Gate

Push and release the LOCK button on the RKE
transmitter to lock all doors. The turn signals will
flash to acknowledge the lock signal.

To Turn Off Flash Lights With Lock

This feature will cause the turn signal lights to
flash when the doors are locked or unlocked
with the RKE transmitter. This feature can be
turned on or turned off. To change the current
setting, proceed as follows:
• For vehicles equipped with the EVIC, refer to
"Electronic Vehicle Information Center (EVIC)/
Personal Settings (Customer-Programmable
Features)" in "Understanding Your Instrument
Panel" for further information.
• For vehicles not equipped with the EVIC,
perform the following steps:
1. Push the RKE transmitter UNLOCK button
for 4 to 10 seconds.
2. While the UNLOCK button is pushed, (after
four seconds) push the RKE transmitter
LOCK button. Release both buttons.
3. Test the "Flash Lights With Lock" feature
outside of the vehicle by pushing the RKE
transmitter LOCK button with the ignition
switch in the LOCK position and the ignition
key removed.
NOTE:
Pushing the RKE transmitter LOCK button
while you are in the vehicle will activate the
Vehicle Security Alarm. Opening a door with
the Vehicle Security Alarm activated will
cause the alarm to sound. Push the RKE
transmitter UNLOCK button to deactivate
the Vehicle Security Alarm.
The "Flash Lights With Lock" feature can be
reactivated by repeating this procedure.
17