To Lock The Doors And Swing Gate; Things To Know Before Starting Your Vehicle 21; Using The Panic Alarm - Jeep 2009 Wrangler Owner's Manual

4. Test this feature while outside of the vehicle, by
pressing the LOCK/UNLOCK button on the RKE trans-
mitter.
NOTE: Pressing the LOCK button while you are inside
of the vehicle will activate the Vehicle Security Alarm.
Opening a door with the Vehicle Security Alarm acti-
vated will cause the alarm to sound. Press the UNLOCK
button to deactivate the Vehicle Security Alarm.
5. If the desired programming was not achieved or to
reactivate this feature, repeat the above steps.

To Lock the Doors and Swing Gate

Press and release the LOCK button on the RKE tranmitter
to lock all doors. The turn signals will flash and the horn
will chirp once to acknowledge the lock signal. If desired,
the "Sound Horn On Lock" feature can be turned on or
off using the following steps:
1. Press the LOCK button for 4 to 10 seconds.

THINGS TO KNOW BEFORE STARTING YOUR VEHICLE 21

2. While the LOCK button is pressed (after four seconds),
press the PANIC button. Release both buttons.
The "Sound Horn On Lock" feature can be reactivated by
repeating this procedure.

Using The Panic Alarm

To turn the Panic Alarm feature on or off, press and hold
the PANIC button on the RKE transmitter for at least one
second and release. When the Panic Alarm is activated,
the headlights and park lights will flash, the horn will
pulse on and off and the interior lights will turn on.
The Panic Alarm will stay on for three minutes unless
you turn it off by pressing the PANIC button a second
time, or if the vehicle speed is 5 mph (8 km/h) or greater.
NOTE: When you turn off the Panic Alarm by pressing
the PANIC button a second time, you may have to be
closer to the vehicle due to the radio frequency noises of
the system.
2