Customer Key Programming; General Information; Vehicle Security Alarm - If Equipped; Rearming Of The System - Jeep Wrangler Owner's Manual

At the time of purchase, the original owner is
provided with a four-digit Personal Identifica-
tion Number (PIN). Keep the PIN in a secure
location. This number is required for authorized
dealer replacement of keys. Duplication of keys
consists of programming a blank key to the
vehicle electronics. A blank key is one which
has never been programmed. See your autho-
rized dealer if you require replacement or ad-
ditional keys for your vehicle.
NOTE:
When having the Sentry Key Immobilizer
system serviced, bring all vehicle keys with
you to the authorized dealer.

Customer Key Programming

See your authorized dealer if you require re-
placement or additional keys for your vehicle.

General Information

The Sentry Key operates on a carrier fre-
quency of 433.92 MHz. The Sentry Key Immo-
bilizer system will be used in the following
European countries, which apply Directive
1999/5/EC: Austria, Belgium, Czech Republic,
Denmark, Finland, France, Germany, Greece,
Hungary, Ireland, Italy, Luxembourg, Nether-
lands, Norway, Poland, Portugal, Romania,
Russian Federation, Slovenia, Spain, Sweden,
Switzerland, Yugoslavia, and United Kingdom.
Operation is subject to the following conditions:
• This device may not cause harmful interfer-
ence.
• This device must accept any interference
that may be received, including interference
that may cause undesired operation.
VEHICLE SECURITY ALARM — IF
EQUIPPED
The Vehicle Security Alarm monitors the vehicle
doors, hood, swing gate, and ignition for unau-
thorized operation.
If something triggers the alarm, the Vehicle
Security Alarm will sound the horn intermit-
tently, flash the headlights and taillights, and
flash the Vehicle Security Light in the cluster.

Rearming Of The System

If something triggers the alarm, the Vehicle
Security Alarm will signal with the siren for
30 seconds. If the triggering device is not
deactivated the siren will sound again after a
five second delay for another 30 seconds. If the
trigger remains present this cycle will repeat for
up to five minutes.

To Arm The System

1. Remove the key from the ignition switch and
exit the vehicle.
2. Lock the doors and liftgate by pressing the
power door LOCK switch or the LOCK button
on the Remote Keyless Entry (RKE) transmitter.
NOTE:
The Vehicle Security Alarm will not arm if
you lock the doors with the manual door
lock plungers or the driver's door lock cyl-
inder.
3. Close all the doors.
The Vehicle Security Light in the instrument
cluster will flash rapidly for about 16 seconds to
signal that the Vehicle Security Alarm is arming.
During this period, opening any door or the
swing gate will cancel the arming process. If
the Vehicle Security Alarm arms successfully,
the Vehicle Security Light will flash at a slower
rate to indicate the alarm is set.
15