Jeep Wrangler Owner's Manual page 155

WARNING!
A malfunctioning catalytic converter, as refer-
enced above, can reach higher temperatures
than in normal operating conditions. This can
cause a fire if you drive slowly or park over
flammable substances such as dry plants or
wood or cardboard, etc. This could result in
death or serious injury to the driver, occupants
or others.
27. Electronic Stability Program (ESP)
Indicator Light / Traction Control System
(TCS) Indicator Light
If the Electronic Stability Program
(ESP) / Traction Control System
(TCS) Indicator Light begins to
flash during acceleration, ease up
on the accelerator and apply as
little throttle as possible. This indi-
cator light starts to flash as soon as the tires
lose traction and the Electronic Stability Pro-
gram (ESP) becomes active. The ESP/TCS
Indicator Light also flashes when TCS is active.
Be sure to adapt your speed and driving to the
prevailing road conditions. If the ESP/TCS Indi-
cator Light is on solid, the ESP system has
been turned off by the driver or a temporary
condition exists that will not allow full ESP
function.
28. O/D (Overdrive) Off Indicator Light
This light will illuminate when the O/D
OFF button has been selected and over-
drive has been turned off. The O/D OFF
button is located on the center console.
29. Sway Bar Indicator Light — If
Equipped
This light will illuminate when the
front sway bar is disconnected.
30. Electronic Stability Control (ESC) OFF
Indicator Light — If Equipped
This light indicates the Electronic
Stability Control (ESC) is off.
31. Electronic Throttle Control (ETC) Light
This light informs you of a problem
with the Electronic Throttle Control
(ETC) system. If a problem is de-
tected while the engine is running,
the light will either stay on or flash
depending on the nature of the problem. Cycle
the ignition key when the vehicle is safely and
completely stopped and the shift lever is
placed in the PARK position. The light should
turn off. If the light remains on with the engine
running, your vehicle will usually be drivable;
however, see an authorized dealer for service
as soon as possible.
If the light continues to flash when the engine is
running, immediate service is required and you
may experience reduced performance, an el-
evated / rough idle, or engine stall and your
vehicle may require towing. The light will come
on when the ignition is first turned to ON/RUN
and remain on briefly as a bulb check. If the
light does not come on during starting, have
the system checked by an authorized dealer.
153