Personal Settings (Customer-Programmable Features) - Jeep Wrangler Owner's Manual

Manual Compass Calibration
If the compass appears erratic and the "CAL"
indicator does not appear in the EVIC display,
you must put the compass into the Calibration
Mode manually as follows:
1. Start the engine. Leave the shift lever in
PARK in order to enter the EVIC Programming
Menus.
2. Press the MENU button until the Personal
Settings (Customer-Programmable Features)
menu displays in the EVIC.
3. Press the DOWN button until "Calibrate
Compass" displays in the EVIC.
4. Press and release the SELECT button to
start the calibration. The "CAL" indicator will
display in the EVIC.
5. Complete one or more 360–degree turns (in
an area free from large metal or metallic ob-
jects) until the "CAL" indicator turns off. The
compass will now function normally.
Compass Variance
Compass Variance is the difference between
Magnetic North and Geographic North. To
compensate for the differences, the variance
162
should be set for the zone where the vehicle is
driven, per the zone map. Once properly set,
the compass will automatically compensate for
the differences and provide the most accurate
compass heading.
NOTE:
Magnetic materials should be kept away
from the top of the instrument panel, this is
where the compass sensor is located.
Compass Variance Map
1. Turn the ignition switch ON.
2. Press and hold the COMPASS button for
approximately two seconds.
3. Press the DOWN button until "Compass
Variance" message and the last variance zone
number displays in the EVIC.
4. Press and release SELECT button until the
proper variance zone is selected according to
the map.
5. Press and release the COMPASS button to
exit.
Personal Settings (Customer-
Programmable Features)
Personal Settings allows the driver to set and
recall features when the vehicle speed is at
0 mph (0 km/h) (manual transmission) or when
the shift lever is in PARK (auto transmission).
Press and release the MENU button until Per-
sonal Settings displays in the EVIC.
Use the DOWN button to display one of the
following choices:
Language
When in this display you may select one of five
languages for all display nomenclature, includ-
ing the trip functions and the navigation system
(if equipped). Press the SELECT button while in
this display to select English, Espanol or Fran-