Esc Activation/Malfunction Indicator Light And Esc Off Indicator Light; Trailer Sway Control (Tsc) - Jeep Wrangler Owner's Manual

4. Wait approximately five seconds for the sys-
tem bulb check.
5. Turn and hold the steering wheel one-half
turn to the right (clockwise).
6. Press and hold the ESC OFF button for
seven seconds.
7. Turn the steering wheel back to center, and
turn and hold an additional one-half turn to the
left (counterclockwise).
8. Press and hold the ESC OFF button for
seven seconds.
9. Turn the steering wheel back to center.
10. Press and hold the ESC OFF button for
seven seconds.
11. Cycle the ignition key to OFF.
After performing the ESC disable procedure
correctly, "ESC OFF" will be displayed in the
odometer for approximately 12 seconds each
time the ignition is moved to ON. Repeating the
ESC disable procedure will re-enable normal
ESC operation.
ESC Activation/Malfunction Indicator
Light and ESC OFF Indicator Light
The "ESC Activation/Malfunction
Indicator Light" in the instrument
cluster will come on when the igni-
tion switch is turned to the ON
position. It should go out with the
engine running. If the "ESC
Activation/Malfunction Indicator Light" comes
on continuously with the engine running, a
malfunction has been detected in the ESC
system. If this light remains on after several
ignition cycles, and the vehicle has been driven
several miles (kilometers) at speeds greater
than 30 mph (48 km/h), see your authorized
dealer as soon as possible to have the problem
diagnosed and corrected.
The "ESC Activation/Malfunction Indicator
Light" (located in the instrument cluster) starts
to flash as soon as the tires lose traction and
the ESC system becomes active. The "ESC
Activation/Malfunction Indicator Light" also
flashes when TCS is active. If the "ESC
Activation/Malfunction Indicator Light" begins
to flash during acceleration, ease up on the
accelerator and apply as little throttle as pos-
sible. Be sure to adapt your speed and driving
to the prevailing road conditions.
NOTE:
• The "ESC Activation/Malfunction Indica-
tor Light" and the "ESC OFF Indicator
Light" come on momentarily each time
the ignition switch is turned ON.
• Each time the ignition is turned ON, the
ESC system will be ON even if it was
turned off previously.
• The ESC system will make buzzing or
clicking sounds when it is active. This is
normal; the sounds will stop when ESC
becomes inactive following the maneuver
that caused the ESC activation.
The "ESC OFF Indicator Light" in-
dicates the Electronic Stability
Control (ESC) is off.

Trailer Sway Control (TSC)

TSC uses sensors in the vehicle to recognize
an excessively swaying trailer and will take the
215