To Open And Close The Hood; Lights; Multifunction Lever; Headlights And Position Lights - Jeep Wrangler Owner's Manual

TO OPEN AND CLOSE THE HOOD

Release both the hood latches.
Hood Latch
Raise the hood and locate the safety latch,
located in the middle of the hood opening.
Push the latch to the left side of the vehicle, to
open the hood. You may have to push down
slightly on the hood before pushing the safety
latch. Insert the support rod into the slot on the
hood.
To close the hood, remove the support rod from
the hood panel and place it in the retaining clip.
Lower the hood slowly. Secure both of the hood
latches.
WARNING!
Be sure the hood is fully latched before driving
your vehicle. If the hood is not fully latched, it
could open when the vehicle is in motion and
block your vision. Failure to follow this warn-
ing could result in serious injury or death.

LIGHTS

Multifunction Lever

The multifunction lever controls the operation of
the position lights, headlights, headlight beam
selection, passing lights (flash-to-pass), fog
lights (if equipped), instrument panel light dim-
ming and turn signals. The lever is located on
the left side of the steering column.
Multifunction Lever

Headlights and Position Lights

Turn the end of the multifunction lever to the first
detent for position lights and instrument panel
lights. Turn to the second detent for headlight
operation.
NOTE:
Lens fogging can occur under certain atmo-
spheric conditions. This will usually clear as
atmospheric conditions change to allow the
condensation to change back into a vapor.
Turning the lamps on will usually accelerate
the clearing process.
Headlight Switch
83