Jeep Wrangler Owner's Manual page 46

ISOFIX Child Seat – Four-Door Models
Size Seating Position
Fixture
Class
Mass
Front
Group
Pas-
senger
E ISO/R1 X
0 - Up
to 10 kg
(1) X
E ISO/R1 X
D ISO/R2 X
0+ - Up
to 13 kg
C ISO/R3 X
(1) X
D ISO/R2 X
C ISO/R3 X
B ISO/F2 X
I - 9 to
B1 ISO/ X
18 kg
F2X
A ISO/F3 X
(1) X
II - 15 (1) X
to 25 kg
III - 22 (1) X
to 36 kg
(1) — For the child restraint systems (CRS)
which do not carry the ISO/XX size class iden-
tification (A to G), for the applicable mass
group, the manufacturer will indicate the ve-
44
hicle specific ISOFIX child restraint system(s)
recommended for each position.
Key of letters used in the table above:
Rear Rear
Out- Cen- IUF = Suitable for ISOFIX forward child restraint
board ter
systems of "universal" category approved for
IUF X
use in the mass group.
X X
IL = Suitable for particular ISOFIX child restraint
IUF X
systems (CRS) given in the attached list. These
X X
ISOFIX CRS are those of the "specific vehicle",
X X
"restricted" or "semi-universal" categories.
X X
X = ISOFIX position not suitable for ISOFIX
X X
child restraint systems in this mass group
X X
and/or this size class.
IUF X
IUF X
Installing The ISOFIX-Compatible Child
Restraint System
IUF X
We urge you to carefully follow the directions of
X X
the manufacturer when installing your child
X X
restraint. Not all child restraint systems will be
installed as described here. Again, carefully
X X
follow the installation instructions that were pro-
vided with the child restraint system.
The rear seat lower anchorages
are round bars, located at the rear
of the seat cushion where it meets
the seatback, and are visible when
you lean into the rear seat to install
the child restraint. You will easily
feel them if you run your finger along the
intersection of the seatback and seat cushion
surfaces.
ISOFIX Anchorages (Two-Door Models)