Datasync Hose - Cyclo Vac Central vacuum system Owner's Manual

c
GX series: check the bag, and change if necessary.
HX series: check the bag or the dust canister and change/
empty if necessary.
DL series only – empty dust recipient and clean filters
d
Replace filter
e
Maintenance of the power unit is required.
f
Four green LEDs indicate the power level chosen. When all
four flash, they indicate an automatic shut-off (after one hour of uninterrupted
use). Simply restart the power unit by pressing the hose handle switch.
g
Press the power button to start the power unit at full power. To reduce power
level, press briefly on the switch. Power level will reduce by one level. From
power level 1 (lowest), the power unit will proceed to power level 4 (highest).
To stop the power unit, keep pressing the switch for 2 seconds.
DEMO MODE:
Demo mode: If you initiate a demonstration of the DataSync Information Center on
the power unit, (by pressing the reset button on the vacuum unit for 5 seconds) the
hose will also enter a demo mode of LEDs. To stop the demonstration, simply press
the power button on the hose handle
20

DataSync Hose

The light emitting diodes on the DataSync hose will
signal, by flashing, that it is time to change the bag or
empty the canister, and even when maintenance is
required. They do not indicate a problem with the
vacuum system, and will not hinder or stop the use
of the vacuum power unit.
g
for one second.
Operating Instructions
(DL, GX & HX Series)
1 2
4
5
3