H & Hx Series - Hybrid Filtration - Cyclo Vac Central vacuum system Owner's Manual

H & HX Series - Hybrid Filtration
Use with bag
Replace the bag when full. Frequency will depend on use of the unit. For the
HX series, the DataSync monitor will indicate when to change the bag. These
indications are provided by an electronic timing board, only as a reference guide.
For maintenance instructions, please refer to page 23.
Use without bag
We recommend you empty the dust receptacle and clean
the permanent filter at least each season, depending on
use of your central vacuum.
1. To empty the dust receptacle:
Disconnect the unit from the electric outlet. Unlatch the
two clips, remove the receptacle (figure 20), and empty
into an appropriate container.
2. To clean the permanent filter (figure 21):
within a large plastic bag. Hold it tightly around the
unit with one hand.
removing the plastic bag.
3. Replace the dust receptacle and seal with the two clips.
4. Reconnect the unit to the electric outlet.
Note:
Should the filter become stained, or emit an unpleasant
odor, it may be washed in cold water (without bleach).
Rinse and dry well before replacing. Do not tumble dry.
Maintenance
figure 20
figure 21
25