Operating Instructions; Hose Hook-Up & Inlets - Cyclo Vac Central vacuum system Owner's Manual

Please verify that your central vacuum is properly connected to the piping system
and to a grounded electrical outlet, and that the low voltage wires are connected
to the unit (see pages 14 to 16). Then, read the complete owner's manual and
proceed with a quick verification of your unit's installation:
To start your central vacuum, simply insert the hose in the vacuum inlet of your
choice. Please ensure that the tab on the hose end is properly lined up with the
slot in the inlet opening (figure 7). If your hose handle has an integrated on/off
switch, simply slide the switch to the "on" position.
Do not try to open another inlet while your system is in operation, as it may
damage the inlet's rubber seal.
check other inlets for leaks.
works properly.
Hose Hook-up & Inlets
figure 7

Operating Instructions

17