Hose Hook-Up & Inlets - Cyclo Vac HD Series Owner's Manual

Hose Hook-up & Inlets
Please verify that your unit is properly connected to the dust collector, and that
the collector is correctly connected to the piping system. Also verify that the unit
is properly connected to a grounded electrical outlet and that the low voltage
wires are connected to the unit. Then, read the complete owner's manual and
proceed with a quick verification of your unit's installation:
To start your unit, simply insert the hose in the vacuum inlet of your choice.
Please ensure that the tab on the hose end is properly lined up with the slot in
the inlet opening (figure 9). If your hose handle has an integrated on/off switch,
simply slide the switch to the "on" position.
Do not try to open another inlet while your system is in operation, as it may
damage the inlet's rubber seal.
check other inlets for leaks.
works properly.
14
figure 9