Datasync Monitor - Cyclo Vac Central vacuum system Owner's Manual

(DL, GX & HX Series)
Your central vacuum unit is equipped with an electronic timing device that will
recommend proper maintenance of your vacuum system. These signals are only
suggestions and do not indicate a problem with your vacuum system. They will not
stop or hinder the use of the vacuum.
1
2
3
4
Please note that maintenance information provided by these four icons (2, 4, 5,
and 6) will also appear on the DataSync hose handle (see details on next page).
DEMO MODE
Demo mode: to initiate a demonstration of the Information Center on the power
unit, press the reset button
press the reset button
c
Timer – indicates hours the unit has been
operated
d
Flashing wrench – mechanical maintenance of the
power unit is recommended
e
Turbine
Without movement – unit is connected to a power
source
Movement – unit is turned on - operating
Speed of movement according to power level
5
chosen
6
f
Flashing Bag – GX series: check the bag, and
change if necessary.
7
HX series: check the bag or the canister, and
change/empty if necessary.
g
Flashing Filter – DL series
Empty dust recipient and clean filters
h
Flashing Carbon Dust Filter
Replace filter
i
Reset – to stop the flashing icons, press the reset
button for one second.
i
for 5 seconds. To stop the demonstration, simply
i
.
Operating Instructions

DataSync Monitor

19