Antimicrobial Permanent Filter - Cyclo Vac Central vacuum system Owner's Manual

GS & GX Series - Electrostatic Bag
(Except GS115 model)
Replace the bag when full. Frequency will
depend on use of the unit. For the GX
series,the DataSync monitor will indicate
when to change the bag. These indications
are provided by an electronic timing board,
only as a reference guide.
1. To access the bag, unlatch the two
clips and remove the dust receptacle
(figure 14).
2. Remove the used bag and seal bag opening
(adhesive seal provided on each bag).
Discard used bag.
3. Install the new bag, ensuring the tabs on
the bag adaptor are aligned with the slots
in the bag collar (figure 15).
4. Ensure adequate sealing by inserting bag
as far as retention ring (figure 16 - A).
Rotate bag 20° (figure 16 - B) to ensure
tabs on bag adaptor are no longer aligned
with the slots in the bag collar.
5. Put the dust receptacle back in place and
seal by latching both clips.
Only use genuine Cyclo Vac replacement bags.
Failure to do so could void the warranty on
your vacuum unit.

Antimicrobial Permanent Filter

This drum-shaped filter requires no maintenance. It will be checked by the
authorized dealer when you have the vacuum power unit inspected, after
approximately 500 hours of use.
tabs on bag
adaptator
retention ring
Maintenance
figure 14
figure 15
A
B
figure 16
23