Low Voltage Connections - Cyclo Vac Central vacuum system Owner's Manual

Low Voltage Connections

Connect the low voltage wires to the low voltage inlet on your unit.
To do so:
1. Strip wires over 1 cm (½ inch) (figure 3).
2. Gently press on the toggle to open the connector (figure 4).
3. Insert stripped wire (figure 5).
4. Release toggle to secure wire in connector (figure 6).
5. Repeat steps 2 to 4 for second connector.
To disconnect:
1. Gently press on the toggle to open the connector.
2. Remove low voltage wire from connector.
16
figure 3
figure 5
Installation
figure 4
figure 6