Weidmuller WI-GTWY-9 User Manual page 45

WI-GTWY-9-xxx Wireless Gateway
can also change password at any time by over-typing the passowrd.
If you are starting a new project, you have the option of "Enabling Security". This option enables
encryption of the data
sent over the radio. -
please read Section
4.2.2 and the
associated warnings
before using this
option.
To proceed with the
configuration, double-
click on the project
name on the menu on
the left side of the
screen. "Units" will
appear. You can now
enter the types of units
which will be used in
the system. If you double-click on "Units"or select the "+" sign beside "Units", then the modules
that have already been created will be displayed.
Loading configuration from an existing module
To load the configuration from a module, connect the module to the PC via the RS232 cable, put
the module into "Configuration Mode" by pressing the configuration button on the top end-plate,
and click on "Load Unit". This will allow you to view the module configuration, change it, or
copy it for another module - refer to section 4.3 for full
details.
Adding a new module to the system configuration
To add a new module to the system configuration, click
"Units" on the left-hand menu and then "Add Unit".
Select the type of module from the list. For WI-GTWY-
xxx modules, you will be asked to select the bus
protocol. This must match the WI-GTWY-9-xxx module
type you have installed.
You have the option of selecting a unit address for the
module, or allowing the program to select one
automatically. If you choose to select the unit address the
program will display the list of available addresses for
to select - valid addresses are 1 – 95.
V1.18
on
9-
you
45