Weidmuller WI-GTWY-9 User Manual page 147

WI-GTWY-9-xxx Wireless Gateway
You can display the register values in Decimal by selecting "Dec" at the bottom of the screen. If
you select "Dig", the values will be displayed as a 0 or 1 digital value (1 if the 16-bit value is
greater than 50% - that is, the most significant bit is 1). If you select "Anlg", the value will be
displayed as a 4-20mA range.
To stop the decoding of "comms logging", select the "Stop Comms" button. You should then
also stop the WI-GTWY-9-xxx from outputting radio comms by pulling up the terminal menu
(i.e. press "terminal" and then hit enter in the terminal screen) and selecting "d) Disable Comms
Logging".
Option e) Add Time Stamps
This option in the debug menu will add a timestamp to each displayed radio message. The
timestamp is based on the WI-GTWY-9-xxx internal real time clock. This option is normally
used only if monitoring is done from a terminal package only, and configuration software is not
being used to decode the communications.
When configuration software is being used to decode the radio comms (see above) time stamps
can be added by selecting the "Time Stamps" checkbox. This will display the current time and
date (according to the PC Clock) alongside each message. The "Comms log" can be saved to a
file for future reference by selecting "Log to File".
Option f) Current System Address only
This option will ensure that only radio messages that have the same system address as the
connected WI-GTWY-9-xxx are displayed. If you have another system with a different system
V1.18
147