Devicenet Port - Weidmuller WI-GTWY-9 User Manual

WI-GTWY-9-xxx Wireless Gateway

3.9 DeviceNet Port

For WI-GTWY-9-DE1 modules only.
Connection to the DeviceNet Network is via the 5-pin plugable screw terminal connector located
at the antenna end of the module. Pin-outs are specified below.
DEVICENET
CONNECTION
CONNECTION
5-pin plugable screw terminal fieldbus connector:
Pin Signal
1 V-
2 CAN_L
3 SHIELD
4 CAN_H
5 V+
DeviceNet uses termination resistors at each physical end of the bus. The termination resistor
should be 121 ohm. This should be connected between CAN_H and CAN_L on the bus.
SELECTOR DIAGNOSTIC
SWITCHES LED's
ANTENNA
Description
Negative Supply Voltage
CAN_L bus line
Cable shield
CAN_H bus line
Positive supply voltage
CONFIGURATION
ENABLE
V1.18
41