Weidmuller WI-GTWY-9 User Manual page 157

WI-GTWY-9-xxx Wireless Gateway
system address only or "No" for all System addresses.
11. Tick the "Time stamps" option and then select "Log to File" and type in the name of the log file.
12. From now on everything that is received will be logged to this file with a time stamp.
13. The data frames can be decoded by selecting a message and then viewing the panel below the
Terminal windows. (See Below). You can see the System address, Message type, from and to
addresses as well as the data value, which can be viewed in a number of different formats. I.e
Hex, Dec, Analog and Digital.
6.6.2 Comms Log using firmware erlier than V1.70.
This procedure is used for all models, eg MD1, ET1, PR1, PR2, DE1 & M+1.
1. Start W-Series Configuration Utility and open up the appropriate project.
2. Select from the site list the module you wish to monitor comms at.
3. Press the "Diagnostic" button on the right hand side of the configuration screen and a new
window will open headed "Communications
Log".
4. Hold down the indented black button (on the
end of the module) until the ACT LED flashes
(about 5 seconds), release button and you
Click for time stamps
Decoded Data
V1.18
157