Weidmuller WI-GTWY-9 User Manual page 166

Appendix 2
10.10.12.*
[All]
*.*.*.*
The above example will allow all IP addresses beginning with 10.10.12 to access all
protocols in the module. Addresses beginning with 10.10.13 will be able to access the
web server, but not the FTP and Telnet servers. The Modbus/TCP and Ethernet/IP servers
will accept connections from any IP address.
The contents of this file can be redirected by placing the line '[File path]' on the first row,
and a file path on the second. This procedure is exactly the same as with the system file
"web_accs.cfg" (see above).
telwel.cfg
The default Telnet welcome message can be changed by creating this file. It shall contain
the new welcome message in ASCII form. The contents of this file can be redirected by
placing the line '[File path]' on the first row, and a file path on the second.
Example:
[File path]
\my_settings\telnet_welcome_message.txt
ethcfg.cfg
This file contains the network configuration and is read by the module at start up. The
settings in this file may be affected by configuration software and SSI commands. The
format of the file is the following:
[IP address]
192.168.0.150
[Subnet mask]
255.255.255.0
[Gateway address]
192.168.0.1
[DHCP/BOOTP]
OFF
[Speed]
Auto
[Duplex]
Auto
[SMTP address]
0.0.0.0
[SMTP username]
username
[SMTP password]
password
[DNS1 address]
0.0.0.0
[DNS2 address]
0.0.0.0
[Domain name]
weidmuller.com
[Host name]
GUEST
166
(allowable values are "ON" and "OFF")
(allowable values are "Auto", "100", or "10")
(allowable values are "Auto", "Full", or "Half")
(Primary DNS)
(Secondary DNS)
IT Functionlity