Display Setting; Fixture Test; Fixture Information - ProLights Reflex User Manual

16

3.12 DISPLAY SETTING

• Enter MENU mode, select [Display Setting], press ENTER button to confirm.
• Set the desired parameter using the UP/DOWN button and press the ENTER button to confirm the set-
ting.
- [Display Inverse] - Used for reversing display. Select [Display Inverse], press ENTER button to confirm,
present mode will blink on the display, use UP/DOWN button to select [No] (normal display) or [Yes]
(inverse display), press ENTER button to store.
- [Backlight Auto Off] - Select [Backlight Auto Off], press ENTER button to confirm, present mode will blink
on the display, use UP/DOWN button to select [No] (display always on) or [Yes] (display goes off one
minute after exiting menu mode), press ENTER button to store.
- [Backlight Intensity] - Select [Backlight Intensity], press ENTER button to confirm, present mode will blink
on the display, use UP/DOWN button to adjust backlight intensity from 1 (dark) to 10 (bright), press
ENTER button to store.
- [Temperature Unit] - Select [Temperature Unit], press ENTER button to confirm, present mode will blink on
the display, use UP/DOWN button to select °C or °F, press ENTER button to store.
- [Display Warning] - Select [Display Warning], press ENTER button to confirm, present mode will blink on
the display, use UP/DOWN button to select [No] (Normal) or [Yes] (display will show the error warning
when the unit went wrong).
• Press MENU button back to the last menu or let the unit idle one minute to exit menu mode.

3.13 FIXTURE TEST

Auto Test
Allow checking the proper functioning of the unit. Start the automatic test in the following way:
• Press the MENU button and select through directional buttons the [Fixture Test] menu voice, then select
[Auto Test].
• To confirm and start the automatic test press the ENTER button.
Manual Test
Allows you to adjust effects from the control panel to obtain perfect uniformity between the projectors.
• Press the MENU button and select through the directional buttons the [Fixture Test] menu voice, then-
press the ENTER button to confirm the choice.
• Select the parameter to be changed between [Pan, Tilt, etc.] and press the ENTER button to confirm the
choice.
• Set the desired parameter value between the [0 - 255] range using the UP/DOWN buttons and press the
ENTER button to confirm the setting.
• Press the MENU button to go back or wait one minute for automatic exit from the menu.

3.14 FIXTURE INFORMATION

Enter MENU mode, select [Fixture Information], press ENTER button to confirm, use UP/DOWN button to
select options.
- [Fixture use time] - Select [Fixture Use Time], press ENTER button to confirm, fixture use time will show on
the display, press MENU button to exit.
- [Lamp on time] - Select [Lamp on time], press ENTER button to confirm, lamp on time will show on the
display, press ENTER button to confirm, use UP/DOWN button to select [Exit] or [Reset Time], press
ENTER button to confirm. Press MENU button back to the last menu or exit menu mode let the unit
idle one minute.
- [Firmware Version] - Select [Firmware Version], press ENTER button to confirm, firmware version will show
on the display, press MENU button back to exit.
REFLEX