Figure 2-19 Front Bezel - HP 9000 rp3440 Installation Manual

Installing and Configuring
Removing and Replacing System Covers and Bezels
Removing and Replacing Front Bezel
You must remove the front bezel from the chassis to gain access to the power supplies and optical drive.
Removing the Front Bezel
To remove the front bezel parts, perform the following steps:
Figure 2-19 Front Bezel
Step 1. Use the indentation at the top edge of the bezel to pull the bezel away from the chassis and to a 45
degree angle (Figure 2-19).
Step 2. Lift the bezel off the mounting tabs and away from the chassis.
Replacing the Front Bezel
34
Chapter 2