Lan Leds - HP 9000 rp3440 Installation Manual

For system alerts of levels 3–5, you can clear the attention condition on the LED by accessing the logs using
the sl command available in the MP command mode.
You can clear the fault condition for system alerts of level 7 by resolving the problem and cycling power. See
the SL error logs for additional error information.
NOTE Always check the MP status logs in the case of a blinking yellow or red System LED before
replacing any hardware.

LAN LEDs

The front panel LAN LED indicates the system is communicating over the Gigabit or system management
LAN:
• Blinking green; the system is communicating over the LAN
• Solid green; LAN link is established; no current LAN activity
• Not green; no LAN cable attached; LAN network dead or the system is off
10/100/1000 LAN LEDs are on the rear panel:
The following table lists the 10/100/1000 Base-T ethernet LAN connector LEDs.
Table 3-3 10/100/1000 Base-T Ethernet LAN Connector LEDs
LED
1000BT
100BT
10BT
Activity
Four iLO manageability card LAN LEDs are also on the rear panel:
Table 3-4 iLO Manageability Card LAN LEDs
LAN LED
Self-test Top
10BT 2nd from top
100BT 2nd from bottom
Chapter 3
Blinking green, the 1000 MHz with ethernet protocol and twisted-pair wiring is
enabled; off; no link
Blinking green, the 100 MHz with ethernet protocol and twisted-pair wiring is
enabled; off; no link
Blinking green, the 10 MHz with ethernet protocol and twisted-pair wiring is
enabled; off; no link
Blinking green, LAN activity
Location
Description
Color
Yellow
Off
Green
Blinking green
Off
Green
Blinking green
Troubleshooting Using LEDs
State
MP running self-test or error
MP has booted
10BT link established
10BT activity
No link or 100BT link
100BT link established
100BT activity
Troubleshooting
75