Logging In - Proxim ORiNOCO AP-4000MR-LR Quick Install Manual

c. Set
d. Enter a static IP Address for the AP in the field provided. You
must assign the unit a unique address that is valid on your IP
subnet.
e. Enter your network's
f. Enter your network's
g. Enter the SNMP read/write password in the
Password field.
h. Click
i. The Access Point will need to reboot to apply any changes you
made. When the reboot message appears, click OK to reboot the
device and return to the Scan List screen.
j. After allowing sufficient time for the device to reboot, click
Rescan to verify that your changes have been applied.
k. Click the
l. Click the
Change screen.
m. Proceed to the

logging in

Once the AP has a valid IP Address and an Ethernet connection, you may use
your web browser to monitor and configure the AP. (To configure and monitor
using the command line interface, see the AP-4000MR-LR/4900MR-LR User
Guide.)
1. Open a Web browser on a network computer.
2. If necessary, disable the browser's Internet proxy settings.
3. Enter the Access Point's IP address in the browser's
press Enter or Go. This is either the dynamic IP address assigned by a
network DHCP server or the static IP address you manually configured. See
the Using ScanTool
unit's IP address and manually configure a new IP address, if necessary.
4. The login screen appears.
Page 22
IP Address Type to Static.
For new units, the default password is public
OK to save your changes.
Change button to return to the Change screen.
Web Configuration button at the bottom of the
Logging In
section above for information on how to determine the
Subnet Mask.
Gateway IP Address.
section, below.
Copyright © 2007 Proxim Wireless
Read/Write
Address field and