Step 7: Power On The Unit - Proxim ORiNOCO AP-4000MR-LR Quick Install Manual

step 7: Power on the unit

The power injector provides Power-over-Ethernet (PoE), supplying electricity
and wired connectivity to the unit over a single 24 AWG CAT5 (diameter .114 to
.250 inches/2.9 to 6.4 mm). The unit is not 802.3af-compatible. Always use the
supplied power injector to ensure that the unit is powered properly. Note that
the Active Ethernet module provides +48 VDC over a standard CAT5 Ethernet
cable.
Once you have connected the power injector to the Ethernet cabling and
plugged the power injector cord into an AC outlet, the unit is powered on.
There is no ON/OFF switch on the unit. To remove power, unplug the AC cord
from the AC outlet or disconnect the RJ45 connector from the "Data and Power
Out" port on the power injector.
Note:
On FC units, remove power by unplugging the AC cord from the AC outlet or
disconnecting the RJ45 connector from the "J1/Antenna" port on the power
injector.
Depressing the Reload button (on the side of the power injector) for five
seconds during power-up remotely resets the radio to its factory default
settings. You will need to use the end of a pin or paperclip to depress the
button.
Note:
Power injectors supplied with FC units are not equipped with a Reload
button.
To avoid damaging your router/switch, do not connect the RJ45
port labeled either "Data & Power Out" or "J1/Antenna" from the
power injector to your router/switch.
All rights reserved
WARNING!
Page 15