Step 1: Choose A Location; Step 2: Unpack The Shipping Box - Proxim ORiNOCO AP-4000MR-LR Quick Install Manual

step 1: choose a location

To make optimal use of the unit, you must find a suitable location for the
hardware. The range of the radio unit largely depends upon the position of the
antenna. Proxim recommends you do a site survey, observing the following
requirements, before mounting the hardware.
▪ The location must allow easy disconnection of power to the radio if
necessary.
▪ Air must be able to flow freely around the hardware.
▪ The radio unit must be kept away from vibration and excessive heat.
▪ The installation must conform to local regulations at all times.
The unit is designed to directly mount to a pole or wall. Using the supplied
brackets and hardware, you can mount them to a 1.25 inch to 3-inch pole
(outside diameter). Longer bolts (not supplied) are required for mounting the
units to a larger diameter pole. Using just one of the mounting brackets, you
can mount it to a wall or other flat surface.
Caution!
Proxim recommends the use of a lightning arrestor at the building
ingress point. You can purchase the Proxim Lightning Protector;
see the documentation that comes with the Lightning Protector for
more information and installation instructions.

step 2: unpack the shipping Box

1. Unpack the unit and accessories from the shipping box.
2. Note the Ethernet and MAC addresses of the unit, as well as the serial
number. The addresses may be used when configuring the unit. The serial
number is required to obtain support from Proxim. Keep this information in
a safe place.
All rights reserved Page 9