Step 6: Plug In The Cables - Proxim ORiNOCO AP-4000MR-LR Quick Install Manual

step 6: Plug in the cables

1. Plug one end of the CAT5 cable (A) into the RJ45 jack of the unit (B).
Note:
On FC versions, connect the cable to the port labeled "J1 Antenna" on the
power injector (not pictured). This port has 48 VDC power on the RJ45.
2. Connect the free end of the CAT5 cable to the "Data and Power Out" port
on the power injector.
3. To connect the unit through a hub or a switch to a PC, connect a straight-
through Ethernet cable between the network interface card in the PC and
the hub, and between the hub and the RJ45 "Data In" port on the PoE
adapter.
Note:
On FC units, connect the cable between the hub and the RJ45 "J2 PC/
Router" port on the power injector (not pictured).
To connect the unit directly to a PC, connect a cross-over Ethernet cable
between the network interface card in the PC and the RJ45 "Data In" port
on the power injector.
All rights reserved Page 13