Step.4:.Power.on.the.unit - Proxim AP-4000MR-LR Quick Install Manual

step 4: Power on the unit
The.power.injector.provides.Power-over-Ethernet.(PoE),.supplying.electricity.
and.wired.connectivity.to.the.unit.over.a.single.24.AWG.CAT5.(diameter..114.to.
.250.inches/2.9.to.6.4.mm)..The.unit.is.not.802.3af-compatible..Always.use.the.
supplied.power.injector.to.ensure.that.the.unit.is.powered.properly..Note.that.
the.Active.Ethernet.module.provides.+48.VDC.over.a.standard.CAT5.Ethernet.
cable.
Once.you.have.connected.the.power.injector.to.the.Ethernet.cabling.and.
plugged.the.power.injector.cord.into.an.AC.outlet,.the.unit.is.powered.on...
There.is.no.ON/OFF.switch.on.the.unit...To.remove.power,.unplug.the.AC.cord.
from.the.AC.outlet.or.disconnect.the.RJ45.connector.from.the."Data.and.Power.
Out".port.on.the.power.injector.
Note:
On.R1.units,.remove.power.by.unplugging.the.AC.cord.from.the.AC.outlet.or.
disconnecting.the.RJ45.connector.from.the."J1/Antenna".port.on.the.power.
injector.
Depressing the Reload button (on the side of the power injector) for five
seconds.during.power-up.remotely.resets.the.radio.to.its.factory.default.
settings..You.will.need.to.use.the.end.of.a.pin.or.paperclip.to.depress.the.
button.
Note:
Power.injectors.supplied.with.R1.units.are.not.equipped.with.a.Reload.
button.
Caution!
R1.units:.if.you.connect.the."Antenna".jack.to.your.router/switch,.
it.will.inject.48.VDC.on.the.normally.unused.pins.on.the.RJ45..This.
may.damage.the.terminating.resistors.in.your.router/switch.on.the.
unused.pins.
All rights reserved Page 15