Bringing The System To Standby Mode; Using The Solaris Shutdown Command - Sun Microsystems Sun Fire V1280 Site Preparation And Installation Manual

Using the LOM poweron Command
At the lom> prompt, type:
lom>poweron
The system will power on completely. The System Active indicator will be
illuminated in addition to the Source A and Source B indicators. The system will
execute the power on self tests (POST).
Refer to the Sun Fire V1280 System Controller Command Reference Manual for a full
description of the poweron command.

Bringing the System to Standby Mode

This can be achieved in one of five ways:
Using the UNIX shutdown command.
Sending the shutdown command via the LOM port
Sending the shutdown command using the On/Standby switch
Sending the poweroff command via the LOM port
Sending the poweroff command using the On/Standby switch
Note – You should ensure that Solaris is cleanly shut down before powering a
system to standby mode otherwise data is at risk of being lost.

Using the Solaris shutdown Command

At the system prompt, type:
# shutdown -i5
The system will power off to standby mode. The only indicator LEDs to be
illuminated on the system indicator board are the Source A and Source B indicators.
The IB_SSC assembly Active LED will also be illuminated, but not visible from the
front of the system.
84 Sun Fire V1280 Site Preparation and Installation Guide • September 2002