Sending The Lom Shutdown Command; Sending The Shutdown Command Using The On/Standby Switch; Sending The Lom Poweroff Command - Sun Microsystems Sun Fire V1280 Site Preparation And Installation Manual

Sending the LOM shutdown Command

Note – If Solaris is running this command will attempt to halt the system cleanly
before powering down the system to standby mode, and is the equivalent of the
Solaris init 5 command.
At the lom> prompt, type:
lom>shutdown
After Solaris has been stopped, the system will power off to standby mode. The only
indicator LEDs to be illuminated on the system indicator board are the Source A and
Source B indicators. The IB_SSC assembly Active LED will also be illuminated, but
not visible from the front of the system.
Refer to the Sun Fire V1280 System Controller Command Reference Manual for a full
description of the LOM shutdown command.
Sending the shutdown Command Using the On/Standby
Switch
Momentarily press the system On/Standby switch to the left.
This initiates an orderly shutdown of the system into Standby mode. This is
equivalent to issuing the shutdown command at the lom> prompt.

Sending the LOM poweroff Command

Note – You should ensure that Solaris is cleanly shut down before powering a
system to standby mode by this method, otherwise data is at risk of being lost.
At the lom> prompt, type:
lom>poweroff
This will abruptly terminate Solaris.
Do you want to continue? [no]
Type y to continue or press Return to cancel the command.
Appendix C System Setup 85