Gate Status Indication - Centurion D3 User Manual

starts to open or close. The courtesy light timer will function as normal. (Preflash time
can be adjusted to suit, from 1 to 250 seconds, where the default is 5 seconds). By
default pre-flashing is off.
GATE STATUS INDICATION (OPTIONAL)
The controller can provide visual indication inside the house of the position of the gate
and the condition of the battery and power supply. A LED is typically mounted on the
intercom inside the house. The different signals of the LED are shown in the following
table:
16 - Centurion Sliding Gate Operators User Guide
LED STATUS
Slow regular flash
Quick regular flash
Off
On
1 Flash/2 seconds
2 Flashes/2 seconds
3 Flashes/2 seconds
4 Flashes/2 seconds
INDICATION
Gate is opening
Gate is closing
Gate is closed
Gate is open
Courtesy light switched on (see Courtesy
Light Timer, page 15)
Mains failure (D3/D5 only. See Mains
Failure Detection, page 13)
Or:
Over temperature (A10 only. See Thermal
Overload, page 14)
Battery low (D3/D5 only. See Battery Low
Protection, page 13)
Or:
Missed origin (A10 only. See Origin
Sensor Fail, page 14)
Collision shutdown (Except FAAC units)
(See Anti-crushing Device, page 11)