Pedestrian Keyswitch - Centurion D3 User Manual

Visitor outside gate requests entrance.
provided with a "Gate" or "Door Release" pushbutton which, when pressed, sends a
signal to the gate controller to open the gate.
The sequence of operation of this pushbutton is identical to the radio transmitter
described under "Radio Transmitter".
PEDESTRIAN KEYSWITCH (OPTIONAL)
To allow time for removal of the key, there is a 5 second delay before the gate begins
to open. If the courtesy light is connected to the control card it will flash five times,
indicating that the signal has been accepted.
The gate will open approximately 1 metre and then stop. After 5 seconds the gate will
automatically close.
The gate can be held open by keeping the key turned in the keyswitch. As soon as the
key is released back to its normal rest position, the gate will close after the 5 second
10 - Centurion Sliding Gate Operators User Guide
Gate opened from intercom
pushbutton inside house.
The pedestrian keyswitch is fitted to the
gate pillar. It's purpose is to open the
gate a limited amount for pedestrians.
- Fit key into keyswitch and turn key
clockwise as though starting a motor
car.
- Let key spring back to rest position
and remove key immediately.
PRESS TO
OPEN GATE