Battery; Gearbox Oil Level; Power Supply - Centurion D3 User Manual

THE BATTERY (D3/5 OPERATORS ONLY)
CENTURION systems that are fitted with maintenance free lead acid batteries,
should provide at least 3 years of normal service life.
For sites utilizing an external 35A/H battery ensure that the level of liquid (electrolyte
level) is correct. Check for corrosion of the battery terminals. Clean and apply copper
based grease as necessary.
GEARBOX OIL LEVEL (A10 ONLY)
Check the oil level as described in the section, Lubrication, of the Installation Manual.
Should the installation manual be unavailable, please refer to the On Line Manuals on
our website, www.centsys.co.za. Alternatively, please refer to your CENTURION
installer.

POWER SUPPLY

All Centurion/FAAC operators have power supplies separate to the controllers. In the
case of product malfunction, the power supply fuses should be checked.
A10 models are supplied with spare fuses housed in the controller card cover. The
FAAC 844 houses spare fuses inside the lid.
Be careful to replace A10 fuses with those of the correct rating (see diagram overleaf).
The small green light (LED) on the controller marked - "POWER" - indicates if the card
is active. Each power supply has a red light (LED) to indicate mains supply.
GREEN LED
CHARGE/POWER
Depress and
twist to remove
fuse holder
NOTE: D5/D3 OPERATOR PCB SHOWN
Red LED indicate
the mains supply
is switched on.
22 - Centurion Sliding Gate Operators User Guide