Using System Functions From The Outside (Disa: Direct Inward System Access) - Siemens HiPath 500 Operating Instructions Manual

Step by Step
Using System Functions
from the Outside (DISA: Direct Inward
System Access)
If this function has been configured (contact your ser-
vice personnel), you can set up external outgoing calls
from outside the system, just like an internal user. You
can also activate and deactivate the following functions
in your system:
• Reset services and functions,
code #0
• Call forwarding, code:
• Locking and unlocking telephone,
code: 66/#66
*
• Save PIN,
code: 93
*
• Send a message,
code: 68/#68
*
• Leave an advisory message,
code: 69/#69
*
• Group ringing, code:
• Group call, code:
• Suppress caller ID,
code: 86/#86
*
• Waiting tone, code:
• Open door, code:
• Door opener on/off, code:
• Control relay, code
• Do not disturb, code:
• Ringer cutoff function, code:
• Speed-dialing, code:
• Associated service, code:
Precondition: You have a telephone that uses tone di-
aling (DTMF dialing) or you can switch your telephone
to tone dialing. The telephone is not connected to the
system.
o
Set up a call to the system. Enter the station number
(contact your service personnel).
o
Wait for a continuous tone (if necessary switch the tele-
phone to tone dialing), then enter the internal number
that has been assigned to you and the associated PIN.
r
Enter the code (necessary only if programmed in the
system).
page 89
1/#1
*
page 64
page 65
page 82
page 84
81/#81
*
85/#85 page 106
*
page 35
87/#87
*
61 page 30
*
89/#89
*
90/#90
*
97/#97
*
*
7 page 55
*
83
*
Using Other Functions
page 76
page 106
page 24
page 31
page 97
page 27
98/#98 page 28
page 91
93